Home Improvement

Tips For Avoiding Common Mistakes When Installing a Flagpole

Tips For Avoiding Common Mistakes When Installing a Flagpole

Flags flying saturated in the air are usually on flagpoles. Flagpoles are simple enough to set up, but there are many things you should avoid to be able to take pleasure from a clean and successful task.

  • Improper Location

Among the worst errors is locating your brand-new flagpole where it will come into connection with automobiles, yard mowers, bicycles or any other items that could ram memory involved with it. Also, always avoid any overhead obstructions such as power lines. Talk with any municipal regulators or energy companies before you dig to be sure you will not harm buried lines or pipes in your chosen Flagpole installation area.

  • Sloppy Pole Storage

Avoid departing your pole lying down on the floor when it’s shipped. You should improve the pole at the earliest opportunity. Until you are doing, leave it in whatever protective wrapping it will come in. Avoid departing it lying level. Stand it up and keep it dried out until you are prepared to install it.

  • Small Gap Size

Don’t dig the gap for your flagpole set up too small. You should dig a gap four times bigger than the size of the pole. It will also be deep enough, therefore, the flagpole surface sleeve is flush with the top. Usually, do not use fine sand or dirt as fill up throughout the sleeve. Instead, use smashed rocks.

  • Ready-mix Cement

Stay away from ready-mix concrete. Use regular concrete that dries normally. Never position the sleeve without ensuring the filled-in cement is level. Avoid putting too much concrete in the gap so it will not overflow.

  • Extension Slip-Ups

Large poles (like a 40- feet pole) need an expansion piece you put on the finish and place in to the ground sleeve. Do not let the extension showing above the bottom. Do not drive the extension into the ground. You may want to cut it to make it fit.

  • Removal of Plastic material Wrap

Avoid the enticement to eliminate the plastic cover throughout the flagpole. Keep it on for added security during the set up process.

  • Belated Flash Training collar Installation

Don’t establish the pole in to the ground gap before you slide the flash training collar throughout the pole. You won’t have the ability to place it at the top and take it down, so save some aggravation by keeping in mind to set up it on the flagpole before you place the pole in the bottom.

  • Insufficient Shims

Don’t place the pole in the expansion without needing some shims to ensure it stands equally. Use a real wood shim that can take up to the duty. For instance, pieces of cedar shingles work very well for this task.

  • Wrong Drill Little bit for Cleat Holes

Stay away from the wrong-sized drill little bit to make the cleat openings. Use a 1/8- in. bit for a 15-foot pole, a 5/32-inch bit for a 20- or 25-foot pole and a 3/16-inch bit for a 25- to 40-foot pole.

  • Windy Weather

Avoid setting up your flagpole in windy conditions. Such weather can make your job more difficult.